Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Update m3d-crane-quad-quick-start-guide.md #1

Open
wants to merge 1 commit into
base: master
Choose a base branch
from
Open

Update m3d-crane-quad-quick-start-guide.md #1

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
4 changes: 2 additions & 2 deletions m3d-crane-quad-quick-start-guide.md
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -100,13 +100,13 @@ Verify that wiring between the Duet 2 Maestro and the M3D Crane \(including wiri
![](https://lh6.googleusercontent.com/ffGJ93PifCDq5QijJ3I-Uyo-cZbjVMrkEtxqdt-sYJzzW5ijbcS4NAStR6if9kSVCmBoO__tIuZSaMj2Y6G5N5KtTZHIcLgqf2KhcxRe7MM-UZYA2F1NcbiLzVVmt4fRp6TiWyWk)

2. Press retract while pushing filament lightly in, this is to verify that things are working and that you're in the right position and chose the right port. If the filament is ticking in your hands, go ahead and press the filament towards the gear while pushing the extrude button. \(You should to feel the filament grab and pull through.\)
3. Lightly hold the filament in your hands and press extrude again until filament stops extruding. Repeat once mote times for a total of 60 mm fed through.
3. Lightly hold the filament in your hands and press extrude again until filament stops extruding. Repeat one more time for a total of 60 mm fed through.
4. If at any point filament gets stuck proceed to troubleshooting \(Retract and try again. TBD\)
5. Repeat the above procedure for extruder drive 2 and THEN with ports 1 and 3.

## Extrusion: {#extrusion}

* Set the temp to 240C \(nozzle may ooze ignore it\)
* Set the temp to 240C \(nozzle may ooze, ignore it\)
* Change settings to extrude all at 15mm/s and leave the extrude amount at 20mm.
* Confirm your temperature is still set to 240C.
* Hit extrude \(Waiting between steps\) until filament comes out at a steady speed.
Expand Down